By keyes | 20 December 2018 | 0 Comments
New Keyestudio Sensor Shield V2 for BBC micro:bit
keyestudio sensor shield V2 has brought out all the PIO ports on the micro:bit control board into 3PIN interface (GND, VCC, Signal), very easy to connect the micro:bit control board and other sensor modules.
Moreover, it also extends some commonly-used serial communication interfaces into pin or female headers with 2.54mm pin pitch, such as I2C and SPI communication pins.
This shield will allow communication between micro:bit control board and other communication devices.
You can power the micro:bit board through a black DC jack (DC 7-9V) or a mciro USB port (DC 5V) on the shield.
When power the sensor, you could select the supply voltage 3.3V or 5V via jumper cap V1 and V2.
Features:
1. Power input: black DC jack (DC 7-9V) or micro USB port (DC 5V)
2. Voltage output: select 3.3V or 5V via jumper cap V1/V2
3. Comes with a power indicator
4. Extends the PIO of micro:bit into 3PIN interface
5. Serial communication pin
6. I2C communication pin
7. SPI communication pin
Example Use:
Example Use:
Leave a Reply
Your email address will not be published.Required fields are marked. *